Torrium® Controller

Applications

Ideal for pumps with clean, non-volatile liquids without fibres or solids in such applications as :-[list class=special-4][li]Household water supply[/li][li]Irrigation[/li][li]Water transfer[/li][li]Washing systems[/li][li]Pressure boosting[/li][/list]

Features & Benefits

[list class=special-4][li]MADE IN AUSTRALIA[/li][li]Torrium® starts pump on pressure drop and stops pump on low flow (~2 lpm), thus reducing pump cycling for constant and even water pressure.[/li][li]Torrium® measures the pump shut off head each time the pump stops, and sets the cut-in pressure at 80% of shut-off head, so that the consumer is unlikely to notice any pressure change when the pump is switched on. Torrium® adapts each time the pump stops, thus allowing the system to accommodate variations in pump performance or site conditions. Torrium® has a simple indicator and fault LED system. Red constant means that the system is in standby. Green constant means the pump is running.[/li][li]An Amber constant LED indicates that the system has gone to Cistern Fill mode. Cistern Fill mode is activated when the Torrium® detects frequent short cycling, such as may be encountered with a very slow filling toilet cistern. The Torrium® will then ensure the pump continues to operate for at least 2 minutes.[/li][li]Torrium® stops the pump in “loss of prime” circumstances and activates the loss of prime LED indicator sequence (red LED single flash per sequence), thus:- • Protecting the pump from dry run damage • Helps identify installation faults[/li][li]When the Torrium® detects “loss of prime” it waits 5 minutes then goes into auto retry mode, whereby it will restart the pump to see if prime can be re-established automatically. Auto retry occurs at 5 minutes, 30 minutes, 1 hour, 2, 4, 8, 16 and 32 hours. Torrium® will also retry if it detects flow through the system (eg from mains water pressure returning).[/li][li]If Torrium® detects excessive electrical current, such as when a the pump motor is subjected to lock rotor or when someone tries to manually override the Torrium® by holding in the prime button, the Torrium® will shut the pump down and indicate 2 red flashes per sequence.[/li][li]Should the Torrium® detect low incoming voltage (below 180 volts) it will allow the pump to continue to operate if possible, but it will flash two red flashes per sequence over the green run LED.[/li][li]Incoming power lead fitted is 2m long with Australian three pin plug.[/li][li]Power lead to pump motor is 0.67m long with connection for standard Davey motor up to 1.0kW[/li][/list]View the Data Sheet[span class=alert]All pumps must be connected to a suitable power surge protector[/span]